Binaural Room Reverb (BiRR) 2D And 3D v0.2 WiN Linux

Binaural Room Reverb (BiRR) 2D And 3D

78 MB

BiRR2D and BiRR3D are room simulators that accurately emulate the sound produced by a monophonic and omnidirectionnal source perceived by a listener in a rectangular (2D) or parallelepipedic (3D) room.

User can control (x, y, z) dimensions of the room, and position of source and listener in the room. The orientation of the listener can also be adjusted. Wall properties are adjusted with two or three parameters:

Wall absorbtion : a coefficient between 0 an 1, representing a reflection coefficient. The acoustic wave amplitude is multiplied by this coefficient at each wall rebound. Higher values produce a shorter reverb.

Wall high frequency absobtion : this parameter controls the high frequency absorbtion wall rebounds. Higher values produce darker reverb sound.

Wall diffusion : this parameter controls the wall diffusion properties (parameter only available in the ambisonic version, otherwise fixed to 1e-3, but this is subject to change)

The input is mono or stereo, depending on the chosen version (mono in or stereo in). The output sound is a stereo reverberberated sound with one of the following configurations:

Two cardioid microphones in XY configuration

One cardioid and one eight-pattern microphones, in MS configuration

One omni and one eight-pattern microphone, in MS configuration

Binaural receptor based on the HRTF provided by MIT medialab (https://sound.media.mit.edu/resources/KEMAR.html), and equalized to sound as neutral as possible compared to the dry original sound.

Ambisonic output (for the ambisonic version)

The 2D version simulates a 2D rectangular flat domain. Consequently, the produced binaural sound doesn’t consider height information for sources and listener. The 3D version simmulates a parallelepipedic room, height position of the sources and listener. The latter hence involves more cpu computations for the impulse responses calculations.

Direct path and reflections paths
when a parameter is changed, two stereo impluse responses are calculted and sent to convolution processors:

The direct path impluse response.

The impulse response due to multiple reflections on walls.

The effect level of direct path and reflections can be adjusted separately. These can be sought as dry and wet parameters of the reverb, although the produced sound is physically acurate when both parameters are equal.

Stereo width
In the XY configuration, this parameter specifies the angle between the two cardioid microphones. At its minimum the angle is zero and the produced sound is mono. At its maximum value, the angle equals 180 degrees, the microphones being perpendicular to the head axis. In the standard XY configuration, the angle equals 90 degrees, which occurs when the width parameter equals 0.5.

In the MS configurations the stereo with quantifies the amplitude of the figure eight microphone signal (between 0 and 1).

The stereo width parameter has no effect in the binaural configuration.

There is no such parameter in the ambisonic version

Parameters updating
At each parameter update (except reverb levels and head orientation in the ambisonic version), the impulse response is calculated. As each acoustic path has to be calculated, the computation time can be high, in particular if the damping is small.

A number of threads equal to the number of CPUs – 1 is employed for the impulse response calculation, which allows reasonable computation times (At most a few seconds for largest reverberation times on recent CPUs).

Important note: the fact that some calculation time is necessary after each parameter change prevents parameter automation, as they cannot be updated in real time. Consequently, this plugin cannot be used to move sounds in the virtual space.

HOME

BiRR_AmbiRR.0.2_WIN  ( 28 MB )

BiRR_AmbiRR.0.2_LINUX  ( 51 MB )